|
|
Post by Rockalicious on Apr 10, 2022 20:50:30 GMT
On my parts search for my '72 TnT 292 slide project I managed to get a '72 donour bogie sled. I have both stripped down, compared the tunnels and noticed one major difference aside from a couple drain holes drilled in one and not the other. Can anyone give me insight as to what these support bars are for and why the difference between models?
Bogie - bent clutch support?
Slide - Upright support with hole
|
|
|
|
Post by Rockalicious on Apr 19, 2022 21:25:15 GMT
think I figured it out. the upright hole is an earlier production version of the bent bar. Both are hood restraints.
|
|
|
|
Post by olyman on Apr 21, 2022 2:19:50 GMT
The bottom one definitely is a hood restraint that I recognize. It had the stamped metal sliding thing that went through that hole. It was a neat idea that kept the hood in place moreso than a cable but didn't allow the hood to open near as far.
The top one I've never seen before..
|
|
|
|
Post by skidoo294 on Aug 17, 2023 15:05:14 GMT
I know this is an old thread but my 72 tnt 292 has the top one. I bought it from the original owner and the sled has just under 700 miles. Edit to say mine is a bogie sled
|
|
|
|
Post by Rockalicious on Aug 17, 2023 22:07:02 GMT
I know this is an old thread but my 72 tnt 292 has the top one. I bought it from the original owner and the sled has just under 700 miles. Edit to say mine is a bogie sled
Thanks.. From what I can tell the Internet gods say there is no consistancy or atleast nobody is paying enough attention to the hood thing to decipher when they used what. |
|
